Adjusting Half Arm Height - Invacare XtraTM 1026793 Operator And Maintenance Manual

Locknuts

Adjusting Half Arm Height

NOTE: For this procedure, refer to FIGURE 7.2.
1. Remove the half arm from the arm socket.
2. Remove the hex screw, two (2) washers and locknut mounted in the arm socket that
determine the half arm height.
3. Reposition hex screw and one (1) washer to one (1) of three (3) positions in the arm
socket depending on the desired height.
4. Retighten the hex screw and washer to the arm socket with the remaining washer and
locknut.
5. Reinstall the half arm into the arm socket.
6. Repeat STEPS 1-5 for the opposite side, if necessary.
NOTE: If desired height is still not obtainable, refer to Installing the Half Arm on page 42, to
reposition the arm socket on the wheelchair with the top hex screw in the top mounting hole of the
arm socket and the bottom hex screw in the slot of the arm socket.
Locknut
Washer
Part No 1026793
Half Arm
Socket
Washers
Hex Screw
FIGURE 7.1 Installing the Half Arm
Half
Arm Socket
Arm
Hex Screw
FIGURE 7.2 Adjusting Half Arm Height
Coved
Arm
Washers
Wheelchair Frame
Three (3)
Mounting
Positions
43
SECTION 7—ARMS
TOP Hex
Screw
BOTTOM
Hex Screw
Xtra™