Installing Elevating Legrests; Raising/Lowering Elevating Legrests - Invacare XtraTM 1026793 Operator And Maintenance Manual

SECTION 4—FRONT RIGGINGS

Installing Elevating Legrests

NOTE: For this procedure, refer to FIGURE 4.3.
1. Insert the pivot tube into the legrest support and secure it with the bolt and nut.
2. Place legrest on the outside of the wheelchair and insert the mounting pin into the
mounting tube.
3. Rotate legrest toward the inside of the wheelchair until it locks in place.
NOTE: The footplate will be on the inside of the wheelchair when locked in place.
4. Repeat STEPS 1-3 for the opposite legrest.
5. After seated in wheelchair, adjust footrest to correct height by loosening nut and
sliding the pivot tube up or down until desired height is obtained.
6. To release the legrest, push the legrest release handle toward the inside of the
wheelchair and swing the legrest to the outside of the wheelchair.
Footrest Assembly

Raising/Lowering Elevating Legrests

NOTE: For this procedure, refer to
FIGURE 4.4.
Perform one (1) of the following:
• Raising - Pull back on the release
lever until the leg is at the desired
height.
• Lowering - Support leg with one (1)
hand and push release lever
downward with other hand.
Xtra™
Calfpad
Pivot Tube
Bolt and Nut
Footplate
Mounting Tube
FIGURE 4.3 Installing Elevating Legrests
Legrest Release Handle
Mounting Pin
Release Lever
FIGURE 4.4 Raising/Lowering Elevating
30
Legrests
Part No 1026793