Installing Fabric Clothing Guards
NOTE: For this procedure, refer to FIGURE 10.3.
1. Remove the seat cushion, if necessary.
2. Secure the fastening straps of the fabric
clothing guards to the fastening straps
on the seat upholstery.
3. Reinstall the seat cushion, if necessary.
4. Remove the two mounting screws that
secure the back upholstery to the back
canes.
5. Position the D‐rings on the mounting
holes in the back canes.
6. Reinstall the two mounting screws.
Torque to 20‐25 in‐lbs.
7. Run the nylon cord evenly through the
two D‐rings.
8. Run the nylon cord through the cord
lock.
9. Push star wheel into cord lock to hold
the nylon cord in place.
10. Tie a knot in the nylon cord and cut the
excess, if desired.
Part No 1125104
Card Lock
Mounting
Screw and
D-ring
FIGURE 10.3 Installing Fabric Clothing
65
SECTION 10—SEAT
Fabric Clothing Guard
Fastening Strap
Seat Upholstery
Mounting
Screw and
D-ring
Star Wheel
Nylon Card
Guards
ProSPIN™ X4™