Chapter 1 Engine, Transmission & Gear
Clutch/Driven Pulley
REMOVAL
Remove the left crankcase cover, drive pulley
face and drive belt.
Hold the clutch outer with drive pulley holder and
remove the drive pulley nut and clutch outer.
Remove the driven pulley/clutch assembly.
INSPECTION
Check the clutch outer for wear or damage.
Measure the clutch outer I.D.
Service Limit: 154.0 mm (6.063 in)
Check the clutch shoes for wear or damage.
Measure the clutch lining thickness.
Service Limit: 0.5 mm (0.02 in)
NOTE
。 Replace the clutch as a set.
I-44