HER CHEE ATV-320 S Service Manual page 102

Chapter 5 Wheels, Tires & Brakes
REAR WHEEL AXLE RMOVAL
Loosen brake disk flange tighten nuts and
remove the nuts.
Remove brake disk flange assembly.
Push wheel axle to right side and remove axle
with rear sprocket assembly from axle holder.
Remove rear sprocket assembly from axle.
SPROCKET INSPECTION
Check sprocket teeth, replace if show as
illustration.
Loctite
REAR AXLE HOLDER INSPECTION
Check oil seal for broken or damage, replace it if
necessary.
Turn the inner race of each bearing with your
finger. The bearing should turn smoothly and
quietly.
Check the outer race fits tightly in the holder.
Remove and discard the bearing if the races do
not turn smoothly, quietly or if they are fit loosely
in the holder.
NOTE
◦ Replace holder bearing in pairs.
INSTALLATION
Install rear wheel axle in the reverse order of
removal.
NOTE
◦ Apply greases on bushing before installation.
NOTE
◦ Apply Loctite on brake disk flange tighten
nuts when installation.
V-13