HER CHEE ATV-320 S Service Manual page 52

Chapter 1 Engine, Transmission & Gear
ASSEMBLY
Lubricate the inside of the moveable drive face
with grease then install the weight rollers.
NOTE
。 Use 25-30g of grease and apply to the inside
of the moveable drive face evenly.
Specified grease: Lithium based grease
Install the ramp plate.
Apply grease to the drive pulley collar.
Install the drive pulley face collar with the spline
side facing out.
Clean off any grease or oil from the drive pulley
faces.
INSTALLATION
Install the moveable drive face onto the
crankshaft.
Install the drive belt.
Clean the drive pulley face and install it.
Set the recoil dish onto the crankshaft and
loosely install the drive pulley nut.
Apply engine oil to the threads of the drive pulley
nut.
Hold the drive pulley and tighten the drive pulley
nut.
Torque: 90-100 N.m (65-72 ft.lb)
CAUTION
。 Do not allow oil or grease on the drive belt or
pulley face
Reinstall the removed parts in the reverse order
of removal.
I-43