HER CHEE ATV-320 S Service Manual page 26

Chapter 1 Engine, Transmission & Gear
CAMSHAFT INSTALLATION
Remove the timing hole (oil filling) cap from the
right crankcase cover.
Turn the drive pulley counterclockwise and align
the "T" mark on the flywheel with the index mark
on the right crankcase cover.
Insert the camshaft into camshaft holding house
and turn down the intake and exhaust lobe.
Install intake and exhaust rocker arm to cylinder
head.
Tighten the rocker arm/camshaft bearing holder
plate mounting bolt.
Push the cam chain adjuster push rod back into
the adjuster body by pressing the tab down.
Rail the cam chain to the cam sprocket teeth and
install the cam sprocket to camshaft as shown.
Tighten the two cam sprocket holder bolts.
Install the cam chain adjuster spring and sealing
bolt, and tighten the sealing bolt.
Torque: 8 – 12 N.m (6 – 9 ft.lb)
Install the timing hole cap to the right rear cover.
I-17