Items Needed; Hardware Needed - Backyard Discovery Highlander 6010 Owner's Manual

ITEMS NEEDED

(2) G3 Floor Rail
(4) H11 Floor Rail
(2) G2 Base Board
(2) B1 Front Tower Legs
(2) B2 Middle Tower Legs
(2) B3 Back Tower Legs
STEP 1
B e g i n b y i n s e r t i n g 5 / 1 6 " S p i k e T- N u t s i n T o w e r L e g s
(Per Dia.). Then attach G3 Floor Rail to top of B1 Front, B2 Middle and B3 Back
Tower Legs using 5/16"x 4" Hex Bolts,
Position of small pilot holes in G3 Floor Rail between B2 and B3 Tower Legs and
towards top).
Attach H11 Floor Rail to B1 and B2 and another H11 Floor Rail to B2 and B3 with
5/16"x 4" Hex Bolts, 5/16" Lock Washers and
Nuts inserted earlier.
Use Holes in G2 Base Board to Pilot Drill B1, B2 and B3 Tower Legs with 3/16" Drill
Bit. Now attach using 5/16"x 2-3/8" Lag Screws, 5/16" Lock Washers and
Washers .
Repeat Step to construct opposite tower side.
G3
B3
H11
Lock Washers and Fender Washers. (Note:
Fender Washers into the 5/16" Spike T-
H11
B2 B1
G2
Fender
PAGE 21

HARDWARE NEEDED

(22) 5/16 X 4" Hex Bolts
(12) 5/16 X 2 3/8" Lag Screws
(34) Fender Washers
(34) Lock Washers
(22) Spike T Nut
B1
B2
G3
H11
B3
B2
H11
G2
B3
B1