Backyard Discovery Highlander 6010 Owner's Manual page 27

ITEMS NEEDED
(8) E6 Deck Braces
(4) Y41 Ground Stakes
STEP 5
(when using Lag Screws make sure to pilot drill with 3/16"
drill bit.)
Making sure structure is level and plumb, attach two (2) E6 Deck Braces
Flush to top of H4 Floor Rail with 5/16"x 2-3/8" Lag Screws, 5/16" Lock
Washers and Fender Washers and to B1 Front Tower Legs with 5/16"x 2-
3/8" Lag Screw, 5/16" Lock Washer and 5/16" Flat Washer in counter sunk
holes.
Now attach two (2) E6 Deck Braces flush with top of H11 Floor Rails using
5/16"x 2-3/8" Lag Screws 5/16" Lock Washers and
B1 Front Tower Legs with 5/16"x 2-3/8" Lag Screws, 5/16" Lock Washer
and 5/16" Flat Washer in counter sunk holes
Now attach four (4) more E6 Deck Braces to B3 Back Tower Legs and G3
and G7 Floor Rails with 5/16"x 2-3/8" Lag Screws, 5/16" Lock Washers,
Fender Washers and 5/16" Flat Washers
Legs.
ANCHOR:
Position structure at this point making sure that all attachments will be
in the proper space for your yard.
Position playset in permanent location and secure to ground. Measure in 4"
from Tower Legs and 4" from inside of G7 Base board and mark ground.
Now measure in 4" from Tower Legs and 4" from outside G6 Base Board
and mark ground. This should allow enough space to twist Stakes into
ground using screwdriver for leverage.
Twist Stakes until eye is approximately 3" from ground surface.
At this point you will need at least two people to slide the set into position
next to the Stakes. Using eye in Stake as guide drill thru Base Boards with
3/8" drill bit and attach Stakes with 1" Phillips Truss Head Bolts 5/16" Lock
Fender Washer
Washers, s and 1/4" Barrel Nuts as shown.
FENDER
WASHER
BOLT
Note: If your ground is loose, sandy or
rocky you may need to dig holes and
secure Stakes with concrete.
Fender Washer
.
in counter sunk holes
FENDER
WASHER
5/16"
BARREL
NUT
LOCK
WASHER
Metal Stake
H11
Opposite side not shown.
s and to
to Tower
G3
E6
G6
4"
PAGE 25
HARDWARE NEEDED
(24) 5/16" x 2 3/8" Lag Screw
(4) ¼" x 1" Phillips Truss Head Bolt
(4) ¼" Phillips Barrel Nut
(24) Fender Washer
(28) 5/16" Lock Washer
(8) 5/16" Flat Washer
E6
5/16" Flat
Washers
G7
E6
B3
5/16" Flat
Washers
G7
G7
H4
E6
B1
G3
E6
E6
5/16" Flat
Washers
B3
4"