Backyard Discovery Highlander 6010 Owner's Manual page 50

ITEMS NEEDED
(1) A1 Swing Beam
(1) SP1 Beam Support
(1) E2 Beam End Support
(2) E1 Angle Braces
(1) G1 Ground Board
STEP 29
Attach four (4) Swing Hangers to A1 Swing Beam with 3/8"x 5-3/4" Hex Bolts, 3/8" Lock Washers, 3/8" Flat Washers
and 3/8" Spike T-Nuts. Now attach Glider Supports to A1 Swing Beam using 5/16"x 5" WHA Bolts, Fender Washers,
5/16" Lock Washers and 5/16" WHA Barrel Nuts.
Attach A100004 Swing Beam Bracket to A1 with 5/16" x 4" Hex Bolts, Fender Washers and Lock Nuts. Attach A100005
Triangle Brace to A1 using 5/16"x 4" Hex Bolts, Fender Washers and 5/16" Lock Nut.
Attach E1 Angle Braces to SP 1 Beam Support with 3/8"x 6-1/2" Hex Bolt, 3/8" Lock Washer, 3/8" Flat Washer and 3/8"
Spike T-Nut. (Note: Refer to Diagram for inserting spike T-Nut into counter-sunk hole).
Attach E2 Beam End Support to SP1 and E1 angle braces using 5/16"x 3" Lag Screws, 5/16" Lock Washers and Fender
Washers to SP1 and 5/16"x 2-3/8" Lag Screws, 5/16" Lock Washers and Fender Washers to E1 Angle Braces.
Attach G1 Ground Board to E1 Angle Braces with 5/16"x 2" Lag Screws, 5/16" Lock Washers and Fender Washers.
Now attach Swing Beam Support assembly to Swing Beam using 5/16"x 4" Hex Bolts, Fender Washers and 5/16" Lock
Nuts.
& Fender Washers
E1
HARDWARE NEEDED
(2) Glider Supports (Y25G)
(2) Triangle Braces (A100005)
(2) L Braces (A100004) Swing Beam Mount
(4) Swing Hangers (Y40-HD4)
(6) 5/16" Lock Nuts
(6) 5/16" x 4" Hex Bolts
5" WHA Bolt
Lock Washers
Fender Washers
WHA Barrel Nuts
SP1
E2
E1
G1
(8) 3/8" x 5 ¾" Hex Bolts
(9) 3/8" Flat Washer
(9) 3/8" Lock Washer
(9) 3/8" Spike Tee Nut
(2) 5/16" x 3" Lag Screw
(4) 5/16" x 2" Lag Screw
(4) 5/16" x 2 3/8" Lag Screw
A1
Use any convenient
long 3/8" bolt.
PAGE 48
(1) 3/8" x 6 1/2" Hex Bolt
(4) 5/16" x 5" WHA Bolt
(4) 5/16" WHA Barrel Nut
(24) Fender Washer
(20) 5/16" Lock Washer
A100005