9. Store the brackets and interposer board for future use.
10. Optional: Install the front bezel. For instructions, see
on page
11. Install the server system cover. For instructions, see
Cover" on page
Installing and Removing the PCI Riser Assembly
Caution: The PCI riser assembly is NOT hot swappable. Before removing or replacing the PCI
riser assembly, you must first take the server out of service, turn off all peripheral devices
connected to the system, turn off the system by pressing the power button, and unplug the
AC power cord from the system or wall outlet.
Removing the PCI Riser Assembly
1. Observe the safety and ESD precautions at the beginning of this book. See
Information" on page
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the server system cover. For instructions, see
System Cover" on page
4. Disconnect any cables attached to any add-in cards.
5. Lift the riser assembly up to remove it. Use caution to gently ease the riser card
from the add-in card slot so you do not damage the slot or the riser card.
Figure 64. Removing PCI Riser Assembly from the Server System
®
Intel
Server System SR1530CL / SR1530HCL / SR1530HCLS
27.
29.
iii.
28.
"Installing the Front Bezel"
"Installing the Server System
"Removing the Server
AF000982
"Safety
61