Replacing The Front Panel Board (Sr1530Cl); Figure 81. Removing Front Panel Board From Server System (Sr1530Cl) - Intel SR1530CL User Manual

Replacing the Front Panel Board (SR1530CL)

Caution: The front panel board is NOT hot swappable. Before removing or replacing the front
panel board, you must first take the server out of service, turn off all peripheral devices
connected to the system, turn off the system by pressing the power button, and unplug the
AC power cord from the system or wall outlet.
Your server must be operated with a control panel installed.
1. Observe the safety and ESD precautions at the beginning of this book. See
Information" on page
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the server system cover. For instructions, see
System Cover" on page
4. Disconnect the power and data cables connected to HDD1, at the right side of the
system. It is not necessary to remove the HDD1 drive.
5. Disconnect the front panel cable and the USB cable from the front panel board.
6. Remove the two screws that attach the front panel board to the server system. See
letter "A" in the following figure. Save these screws. You will re-install them later.
7. Lift the front panel board from the system. See letter "B".

Figure 81. Removing Front Panel Board from Server System (SR1530CL)

®
Intel Server System SR1530CL / SR1530HCL / SR1530HCLS
iii.
28.
A
B
"Safety
"Removing the Server
AF000996
81