Printhead Installation And Removal Procedures - Avery Dennison 686 User Manual

Printhead Installation and Removal Procedures

Printhead removal procedure
1. Attach the grounding strap to your wrist and the printer.
2. Turn the machine off.
3. Leaving the printhead shut, completely loosen the two mount screws but
leave them loose in the holes.
4. Slowly open the printhead carriage assembly. Maneuver the printhead
down and to the right, pulling the wire pack out.
5. Disconnect the wire pack and carefully remove the printhead.
Printhead installation procedure
1. Position the printhead loosely under the printhead carriage assembly.
2. Connect the wire pack.
3. Position the printhead in the printhead carriage assembly so that the
alignment pegs match up and the printhead fits snugly.
4. Tighten the mount screws.
80 • • • • Appendix E
Users Manual Model 686 / 686 HT