Cleaning The Printhead; Cleaning The Platen, Liner Drive, And Pinch Rollers - Avery Dennison Pathfinder 6059 Equipment Manual

Cleaning the Printhead

The following actions may damage the printhead:
♦
Do not use silicone to clean or lubricate.
♦
Do not use sharp objects to remove adhesive or label particles from the printhead area.
♦
Do not touch the printhead with your fingers.
To clean the printhead:
1. Turn off the printer.
2. Open the supply cover and remove the supplies.
3. Check the supply holder for adhesive buildup and clean it
if necessary.
Note: Ground yourself by touching a metal object before
cleaning the printhead. Grounding prevents
electrostatic discharge, which may damage the
printhead.
4. Clean the printhead area of all adhesive and label
pieces using a Cleaning Pen or a soft cloth
moistened with isopropyl alcohol. Let the
printhead dry.
5. Reload the supply roll and close the supply
cover.
6. Turn on the printer.

Cleaning the Platen, Liner Drive, and Pinch Rollers

Clean these rollers when you see adhesive build-up or when a label is wrapped around them.
1. Turn off the printer, open the supply cover, and open the label deflector.
2. Remove the supplies.
3. Hold the printer upright and
gently push down on the label
deflector. It may be stiff.
4. Use a dry, soft-bristle brush, such
as a toothbrush, to clean the
rollers.
If the brush does not remove
all adhesive, moisten a cotton
swab with isopropyl alcohol
and run the cotton swab
across the roller. Wait a few
minutes for the printer to dry.
5. Reload the supplies, close the
label deflector and supply cover.
6. Turn on the printer.
4-2 Equipment Manual Classification: Avery Dennison – Public
Platen Roller
Liner Drive Roller
Pinch Roller