Special Preset Commands - Bosch VEZ Series User Manual

AutoDome Easy II
17.2.4

Special Preset Commands

Some Pelco mode preset commands have a special meaning
and override the normal Pelco preset function as follows:
Preset Description
Command
33-PRESET Pans the AutoDome Easy II 180° (Flip).
34-PRESET Goes to Zero Pan (original home position).
80-PRESET Toggles the Synchronization Mode between Line Lock and
Crystal (Pelco Frame Scan). This command is available if
commands are unlocked using the Main menu.
81-PRESET Initiates Preset Tour.
92-PRESET Sets the Left pan limit for an AutoScan with Limit Stops
enabled.
93-PRESET Sets the Right pan limit for an AutoScan with Limit Stops
enabled.
94-PRESET Initiates a Preset Tour.
95-PRESET Enables or disables Limit Stops in the Setup Menu for
AutoScan.
Invokes the Pelco main Setup Menu when pressed for 2
seconds.
96-PRESET Stops a scan.
97-PRESET Initiates FastAddress (Pelco Random Scan).
98-PRESET Toggles the Synch. Mode between Line Lock and Crystal
(Pelco Frame Scan). This command is available only for
two (2) minutes after the power is applied and then
reverts to normal preset functionality.
99-PRESET Starts an AutoScan
NOTICE! Some Pelco controllers do not support all the preset
command numbers. Consult the specific Pelco controller's
documentation for supported preset commands.
Bosch Security Systems, Inc.
Alternative Control Protocols | en 115
User Manual F.01U.139.424 | 2.0 | 2009.08