Hardware Configuration; Pelco Keyboard Commands - Bosch VEZ Series User Manual

AutoDome Easy II
17.2.1

Hardware Configuration

The AutoDome Easy II is configured from the factory for RS-485
operation in Pelco Protocol Mode.
1.
2.
17.2.2

Pelco Keyboard Commands

Pelco control commands are composed of a sequence of two
(2) keyboard inputs with the following convention: 1) a
Command Number and 2) a Function key input.
The AutoDome Easy II uses the PRESET command key to save
and recall presets (pre-positions) 1 through 99.
NOTICE! To save a preset, enter the desired number and hold
the PRESET key for approximately two (2) seconds. To recall a
preset, enter the desired preset number (or command) and
momentarily press and release the PRESET key.
Bosch Security Systems, Inc.
Connect the controller's TX terminals to the AutoDome
Easy II's TxD terminals. See the AutoDome Easy II Modular
Camera System Installation Manual for complete wiring
instructions.
Pan or tilt the keyboard joystick to confirm that control has
been established to the AutoDome Easy II (approximately
five (5) seconds).
User Manual
Alternative Control Protocols | en 113
F.01U.139.424 | 2.0 | 2009.08