Special Preset Commands - Bosch VG5 600 Series User Manual

AutoDome 600 Series Analog PTZ Camera
4.2.4

Special Preset Commands

Some Pelco mode preset commands have a special meaning and override the normal Pelco
preset function as follows:
Preset Command
33-PRESET
34-PRESET
80-PRESET
81-PRESET
82-PRESET
92-PRESET
93-PRESET
94-PRESET
95-PRESET
96-PRESET
97-PRESET
98-PRESET
99-PRESET
NOTICE!
Some Pelco controllers do not support all the preset command numbers. Consult the specific
Pelco controller's documentation for supported preset commands.
Bosch Security Systems, Inc.
Description
Pans the AutoDome 180° (Flip).
Goes to Zero Pan (original home position).
Toggles the Synchronization Mode between Line Lock and Internal
(Pelco Frame Scan). This command is available if commands are
unlocked using the Main menu.
Initiates Preset Tour 1.
Initiates Preset Tour 2.
Sets the Left pan limit for an AutoScan with Limit Stops enabled.
Sets the Right pan limit for an AutoScan with Limit Stops enabled.
Initiates a Preset Tour.
Enables or disables Limit Stops in the Setup Menu for AutoScan.
Invokes the Pelco main Setup Menu when pressed for 2 seconds.
Stops a scan.
Initiates FastAddress (Pelco Random Scan).
Toggles the Synch. Mode between Line Lock and Internal (Pelco Frame
Scan). This command is available only for two (2) minutes after the
power is applied and then reverts to normal preset functionality.
Starts an AutoScan
User Manual
Alternative Control Protocols | en
F.01U.270.005 | 2.0 | 2012.06
35