Port Configuration - Korenix JetNet 6710G User Manual

4.3

Port Configuration

Port Configuration group enables you to enable/disable port state, or
configure port auto-negotiation, speed, and duplex, flow control, rate limit
control and port aggregation settings. It also allows you to view port status
and aggregation information.
Following commands are included in this group:
4.3.1 Port Control
4.3.2 Port Status
4.3.3 Rate Control
4.3.4 Port Trunking
4.3.5 Command Lines for Port Configuration
4.3.1 Port Control
Port Control commands allow you to enable/disable port state, or configure
the port auto-negotiation, speed, duplex and flow control.
Select the port you want to configure and make changes to the port.
In State column, you can enable or disable the state of this port. Once you
disable, the port stop to link to the other end and stop to forward any traffic.
The default setting is Enable which means all the ports are workable when
you receive the device.
In Speed/Duplex column, you can configure port speed and duplex mode
of this port. Below are the selections you can choose:
JetNet 6710G/ JetNet 6810G User Manual
61