Wiring Power Inputs - Korenix JetNet 6710G User Manual

2.2

Wiring Power Inputs

The Power input port is located at the top of the front panel and supports
redundant input function via a proprietary assembly capable IP-67 connector
(CDG-L207SA) included in the shipment. If you cannot find this power
connector, please contact your local distributor. For the available input power
range and recommended cable size, please refer to the below table.
Minimum Maximum Recommended Redundant Input
JetNet 6710G-M12
JetNet 6710G-RJ
JetNet 6710G-HVDC
JetNet 6810G-M12
JetNet 6810G-RJ
The JetNet 6810G only supports single power input that binds V1 and V2
together to obtain higher current for the booster.
Use the UL listed LPS Switching power supply to powering the JetNet Switch.
For the power wiring method, please refer to the figures 2.2-1 and 2.2-2.
For system safety and the anti-immunity ability, the chassis ground screw
should be well grounded to the earth ground.
Power Input (DC Voltage)
48 60 48
48 60 48
77 137.5 100
22 27 24
22 27 24
Table 2
Figure 2.2-1
JetNet 6710G/ JetNet 6810G User Manual
Input Conductor
V1, V2
V1, V2
V1,V2
V1, V2 bind together AWG 14 / 2.0
V1, V2 bind together AWG 14 / 2.0
Power Input Voltage
Power Wiring Diagram
Cable Size
AWG No. / Cable Area (mm
AWG 14 / 2.0
AWG 14 / 2.0
AWG 14/ 2.0
16
2
)