Preparation For Management; Preparation For Serial Console - Korenix JetNet 6710G User Manual

3 Preparation for Management

JetNet 6710G / JetNet 6810G series Industrial Managed Switch provides
both in-band and out-band configuration methods. You can configure the
switch via RS232 console cable if you don't attach your admin PC to your
network, or if you lose network connection to your JetNet 6710G /JetNet
6810G. This is so-called out-band management. It wouldn't be affected
by network performance.
The in-band management means you can remotely manage the switch
via the network. You can choose Telnet or Web-based management. You
just need to know the device's IP address and you can remotely connect
to its embedded HTTP web pages or Telnet console.
Following topics are covered in this chapter:

3.1 Preparation for Serial Console

3.2 Preparation for Web Interface
3.3 Preparation for Telnet console
3.1 Preparation for Serial Console
In JetNet 6710G /JetNet 6810G package, Korenix attached one M12 to
RS-232 DB-9 console cable. Please attach RS-232 DB-9 connector to
your PC's COM port, connects M12 to the Console port of the JetNet
6710G. If the serial cable lost, please follow the serial console cable PIN
assignment to find one. (Refer to the appendix).
1. Go to Start -> Program -> Accessories -> Communication -> Hyper
Terminal
2. Give a name to the new console connection.
3. Choose the COM name
4. Select correct serial settings. The serial settings of JetNet 6710G
/JetNet 6810G are as below:
Baud Rate: 9600 / Parity: None / Data Bit: 8 / Stop Bit: 1
5. After connected, you can see Switch login request.
Login the switch. The default username is "admin", password,
6.
"admin"
.
Booting...
Sun Jan 1 00:00:00 UTC 2006
Switch login: admin
Password:
JetNet 6710G (version 1.1.5-20100414-11:04:13).
Copyright 2006-2008 Korenix Technology Co., Ltd.
Switch>
JetNet 6710G/ JetNet 6810G User Manual
26