Table of Contents
Advertisement
PUSHING HANDLES
Abb.
Abb.
2
1
ADJUSTABLE BACK HEIGHT
The height of the back can be adjusted by setting the entire back tube (see the section on "Pushing
handle").
For adjusting the height of the back cover, loosen the fixing screws behind the back tube. Then you
can move the cover upwards or downwards. There are fixing holes every 2 cm in the back tube where
the screws can be retightened. Make sure that all screws are properly tightened before using the
wheelchair.
Only your specialist dealer may adjust the height of the back.
Only with height adjustable pushing handles.
The tube handle (1) is fixed to the back frame (2).
Loosen all the fixing screws (3), including those
provided for suspending the armrests (4).
Now you can pull the tube handle to the desired
height and retighten all the fixing screws (3).
Make sure that the handle tubes (1) are positioned
identically on both sides and that all fixing screws are
properly tightened.
Kindly consult your specialist dealer about the ideal
height of the pushing handle. He would gladly assist
you further.
Check that all screws are fixed securely.
Only with height adjustable pushing handles.
If fitted with height adjustable pushing handles, loosen
the screw handles (1) and pull the pushing handle (2)
to the desired position.
Then retighten the screw handles.
Check that all screws are fixed securely.
i
The back seatbelt cannot be adjusted. The
back height (BH: 30cm, 35cm, 40cm) must
be indicated when ordered.
Instruction Manual Eclips X4
Last updated: May 2003
6
Advertisement
Table of Contents
