Pushing Handles; Mounting Or Removing Backrest; Transfer In And Out The Wheelchair - Vermeiren Inovys II Instruction Manual

2.8

Pushing handles

CAUTION:
Risk of injury - Make sure that the star buttons c c c c are properly
   
tightened.
CAUTION:
Risk of tipping over - Use only the last indentation of the pushing
   
handle tube for the maximum height adjustment.
2.9

Mounting or removing backrest

WARNING:
Risk of injury – Check that the backrest is firmly mounted into the
   
four brackets before using your wheelchair.
WARNING:
    Risk of injury – Avoid getting your fingers, clothes caught during the
assembly process.

2.10 Transfer in and out the wheelchair

CAUTION:
In case you cannot perform the transfer in a safe manner, ask
   
someone to assist you.
CAUTION:
Risk of tipping over of the wheelchair – Do not stand on the foot
   
plates.
The pushing handles can be adjusted in height
depending on the size of the attendant.
1. Loosen the star button c located on the
back of the backrest.
2. Pull the pushing handles into the desired
position (7 positions). Indentions d (steps
30 mm) have been placed into the tubing of
the pushing handles.
3. Retighten the star button c firmly by hand.
The backrest of the wheelchair can be mounted
by following instructions.
1. Mount the backrest into the four brackets
c + d.
2. Turn on the upper star buttons c to lock the
star buttons by hand.
3. Check that the backrest is firmly fixated.
To remove the backrest of the wheelchair:
1. Loosen the upper star buttons c.
2. Pull the backrest upwards out the four
brackets c + d.
ƒ‰‡
Inovys II
2011-11