Adjusting Of The Pushing Handles; Adjusting Of The Tip Cap - Vermeiren Eclips+ 30 Instruction Manual

3.10 Adjusting of the pushing handles

WARNING:
Risk of injury - Make sure that all screws are properly tightened with
the appropriate tool.
WARNING:
Risk of tipping over - Make sure that the tubes of the pushing
handles are positioned identically on both sides.
3.10.1 Pushing handles for the Eclips+
3.10.2 Pushing handles / Back adjusting for the Eclips+ 30°
1
1
4
3
3
2
2

3.11 Adjusting of the tip cap

WARNING:
Risk of injury - Make sure that all screws are properly tightened with
the appropriate tool.
A tip cap is mounted on the lower right back frame that can be adjusted in its height
depending on the seat height of the wheelchair.
The tip cap can be placed in 2 different position with a difference of 15 mm. (The wheelchair
with seat height 500 mm is the tip cap height adjustable in 150 mm and 165 mm).
The tube handle is fixed to the back frame
Adjust the height of the pushing handles as follow:
1. Remove the arm supports.
2. Remove the screws
3. Remove the screws
armrests.
4. Pull the tube handle to the desired height.
Pusing handle height Tube handles
910 mm
(Standard)
925 mm
940 mm
955 mm
970 mm
985 mm
1000 mm
1015 mm
Table 4: Pushing handle heights
5. Retighten all the fixing screws
With the model Eclips+ 30° you can adjust the heigh t
of pushing handles c in back tube d.
1. Loosen the Philips screw e.
2. Set the pushing handles to the required height.
3. Retighten the Philips screw e again.
ƒ‰‡
Eclips+, Eclips+ 30°
.
for suspending the
Tube frame
Hole 9 and 11 Hole 1 and 2
Hole 8 and 10 Hole 1 and 2
Hole 7 and 9 Hole 1 and 2
Hole 6 and 8 Hole 1 and 2
Hole 5 and 7 Hole 1 and 2
Hole 4 and 6 Hole 1 and 2
Hole 3 and 5 Hole 1 and 2
Hole 2 and 4 Hole 1 and 2
properly.

2011-06
.