Table of Contents
Advertisement
STEERING WHEEL ADAPTER
The height of the seat can be adjusted in front of the axle. The inclination of the seat can also be
adjusted when setting the steering wheel adapter.
Fig.
Adjustment of the height and the angle of the seat
The steering wheel adapter (1) is situated at the bottom end of the front frame (2). The height of the
adapter can be adjusted after loosening the fixing screws (3). It should be secured again with the
fastening board. Please take note of the sunken threads in this board (4).
Adjustment of the slope nuts
This figure illustrates the principle. The position of the thread in the fastening boards is indicated by a
number.
A
Shows the frame when the seat is horizontal and the adapter perpendicular to the ground.
B
Shows the frame when the seat is tilted slightly and the adapter is perpendicular (caster
angle).
Make sure that the fastening board is identical on both front wheel adapters and, before using the
wheelchair, that all fixing screws have been tightened properly.
THE AXLE ADAPTER OF THE DRIVING WHEELS
The rear wheels can be mounted at various heights by means of an adjustable axle block, resulting in
different seat heights and/or seat angles. In addition, the rear axle and the back can be mounted in
such a way that tipping over is prevented.
Fig.
Adjusting the height of the seat
(Fig.
(Fig.
(Fig.
Instruction Manual Eclips X4
Abb.
A
Fig.
Last updated: May 2003
B
8
Advertisement
Table of Contents
