Aeroflex NAV 2000R Operation Manual page 7

Signal generator
Table of Contents

Advertisement

WARNING
Do not use the equipment in a manner not specified in this manual!
WARNING
Equipment should only be serviced by authorized personnel.
WARNING
To avoid fire hazard, use only a fuse identical in type, voltage rating, and current
rating as specified on the fuse rating label and/or in the manual.
Proper Power Cord
Use only the power cord and connector appropriate for the voltage and plug
configuration in your country. Use only a power cord that is in good condition.
Refer cord and connector changes to qualified service personnel.
Do Not Operate in Explosive Atmospheres
To avoid explosion, do not operate the equipment in an atmosphere of explosive
gas.
Do Not Attempt to Operate if Protection may be Impaired.
If the equipment appears damaged or operates abnormally, protection may be
impaired. Do not attempt to operate it. When in doubt, have the equipment
serviced.
Cleaning Warning
Keep the equipment dry to avoid electrical shock to personnel or damage to the
equipment. To prevent damage, never apply solvents to the equipment housing.
For cleaning, wipe the equipment with a cloth that is lightly dampened with water,
mild detergent, or alcohol. Do not use aromatic hydrocarbons, chlorinated
solvents, or methanol-based fluids.
Operating Position
Normal operating position is horizontal, on a flat surface. Vertical position is not
considered normal operation.
WARNING
This is a Safety Class 1 Product (provided with a protective earthing ground
incorporated in the power cord). The mains plug shall only be inserted in a
socket-outlet provided with a protective earth contact. Any interruption of the
protective conductor inside or outside of the product is likely to make the product
dangerous. Intentional interruption is prohibited.
WARNING
Equipment is not intended for wet locations. Miscellaneous liquids on or in the
equipment could cause hazardous conditions.
Safety Maintenance.
The operator should check the detachable power supply cord condition. The
equipment should not be operated if the mains inlet is cracked or broken. Any
obvious damage to the case (from a drop or fall) should be checked by service
personnel for loose or damaged parts inside. See parts lists for approved
replacement parts.
NAV 2000R – REVISION 0 – JULY 26, 2007 - PAGE 3
Aeroflex Operation Manual
Warnings
SAFETY AND REGULATORY INFORMATION

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents