Fuse Replacement - Icom IC-F8100 Instruction Manual

■ Fuse replacement

If a fuse blows, or the transceiver stops functioning,
find the source of the problem, and repair it. Then re-
place the damaged fuse with a new, adequately rated
fuse.
RWARNING!
Turn OFF the power and discon-
nect the DC power cable from the transceiver before
performing any work on the transceiver. Otherwise,
there is a danger of electric shock, equipment dam-
age and/or fire or injury.
D DC power cable fuse replacement
Refer the figure described to the right for the DC
power cable fuse replacement.
ATC 30 A fuse
D Internal fuse replacement
q Turn the transceiver upside down.
w Unscrew 4 screws from the bottom cover, then lift
up the bottom cover.
CONNECTION AND INSTALLATION
The IC-F8100 has two fuse types installed for trans-
ceiver protection.
• DC power cable ........................................ ATC 30 A
• Circuitry fuse .............................................. ATC 5 A
e Replace the circuitry fuse as shown in the diagram
below.
• Use the supplied ATC 5 A fuse.
r Reattach the bottom cover to its original position.
6
6
58