Atis Code Programming (For Dutch And German Version Transceivers) - Icom IC-M506EURO Instruction Manual

3
PREPARATION
ATIS code programming
■
The 10 digit ATIS (Automatic Transmitter Identification Sys-
tem) code can be programmed at power ON.
This initial code setting can be performed only once.
After being set, it can be changed by only your dealer
or distributor. If your ATIS code has already been pro-
grammed, this programming is not necessary.
Push [MENU].
q
Rotate dial or push [
w
and then push the softkey below the icon.
• RADIO SETTINGS menu is displayed.
Rotate dial or push [
e
then push [ENT].
Rotate dial or push [
r
[ENT].
Push [BACK] twice.
t
Rotate dial or push [
y
then push the softkey below the icon.
• ATIS code programming screen appears.
• Push [CLEAR] to cancel the programming, and go to the normal
operating mode. In this case, the ATIS function is disabled. To
program the ATIS code, repeat the steps q and y.
8
Ω]/[≈] to select the "RADIO SET" icon
Y]/[Z] to select "CHAN Group," and
Y]/[Z] to select "ATIS," and then push
Ω]/[≈] to select the "ATIS" icon and
(For Dutch and German version transceivers)
Enter your ATIS code in the following manner:
u
• Select a desired number using [∫]/[√]/[Ω]/[≈].
• Push [ENT] or Dial to set it.
• To move the cursor, rotate dial or select either arrow, "←" or "→,"
then push [ENT] or dial.
Repeat step
i
After entering the 10 digit code, "FINISH" is automatically
o
selected, and then push [ENT] or Dial to set it.
!0 The "ATIS CONFIRMATION" screen is displayed.
!1 Enter your ATIS code again for confirmation.
• Enter in the same manner as steps u through o.
!2 When your ATIS code programming is successfully com-
pleted, the screen as shown below is briefly displayed.
• After that, the normal operating screen is displayed.
The programmed ATIS code can be checked in the MENU
screen. (p. 85)
u to enter all 10 digits.