Electrical Specifications - Jandy PureLink Installation And Operation Manual

Page 8
The PureLink electrolytic cell contains bipolar electrodes which perform the
Electrolytic Cell
electrolysis and produce chlorine when energized with DC current. Chlorine
is generated as pool water containing salt passes through the cell. The chlorine
production can be varied by either adjusting the Chlorine Production Level on the
power center or by varying the number of hours the PureLink is on each day. The
PureLink automatically cleans the Cell electrodes once every 3 hours by reversing
polarity. This does not interrupt the production of Chlorine.
Flow/Salinity/Temperature Sensor
there is adequate water flow through the Cell. The salinity portion of the Flow/Temp/
Salinity Sensor detects the level of salt in the pool water. This salt level is displayed
in grams per liter (gpl) on the Liquid Crystal Display (LCD) whenever the salinity
button is pressed. This eliminates the need for manual pool water salinity testing.
Pool Temperature is now available on all models by pressing the
2.2 Electrical Specifications
Circuit Protection
2 pole 20 AMP device at the Electrical Panel.
Model AP700
Input: 115 VAC, 50/60 Hz, 1.5 AMPS
230 VAC, 50/60 Hz, 0.75 AMPS
Output: 22-30 VDC @ 3 AMPS maximum
Chlorine: 0.625 lb. / 24 Hr. (283 gm / 24 Hr.)
External ORP/External Control Connector
Control: AquaLink
Factory wired for 230 VAC service. If available electrical service is 115 VAC, the power supply
wiring must be changed to operate on 115 VAC as shown in Figure 2b.
The PureLink is powered from the LOAD SIDE of the pool circulation pump relay; therefore, if the
available electrical service is 115 VAC, then the pump must also be wired for 115 VAC.
The Flow/Temp/Salinity Sensor only allows the Cell to operate if
RS485 Connector
®
Input: 115 VAC, 50/60 Hz, 2.5 AMPS
230 VAC, 50/60 Hz, 1.25 AMPS
Output: 22-30 VDC @ 6 AMPS maximum
Chlorine: 1.25 lb. / 24 Hr. (567 gm / 24 Hr.)
External ORP/External Control Connector
Control: AquaLink
CAUTION
Temperature
Model AP1400
RS485 Connector
®
button.