Jandy PureLink Installation And Operation Manual page 18

Page 18
Do not operate the electrolytic cell without water circulation. A buildup of flammable gases will result
in hazardous conditions.
Sometimes
Not Covered
From Pump
Flow Sensor Face Flow Sensor Face
Must Be Must Be
Clean Clean
Figure 12. Flow/Temp/Salinity Sensor
Figure 13. Cell Installation
2" x 2" x 1½"
PVC Tee
Figure 14. Pipe Cutout
Connector
DC Cord Plug is Connected
2" x 2" x 1½"
PVC TEE
PVC Unions and 2" Nuts
For a 2" pipe, the cutout is 2¼"
for the Tee.
For a 50 mm pipe, the cutout is
77 mm for the Tee.
NOTE Total length of the PVC
Tee is 4¾".
WARNING
2" x 2" x 1-1/2 "
PVC TEE
Teflon
Tape
Flow / Temp / Sal nity i
Sensor
to Terminal Studs
PVC Union
For a 2" pipe, the cutout is 13
unions, without the Tee.
For a 50 mm pipe, the cutout is 337 mm with the
full unions, without the Tee.
NOTE Total length of the electrolytic cell with the
full unions is 15
2" PVC Union
Detail A
Preferred
Cell
Detail B
Not Preferred
Detail C
Hazardous
O-Ring
Seal
2" PVC Union
and 2" Nut
1
/ " with the full
8
5 / ".
8