Operation - Jandy PureLink Installation And Operation Manual

Page 28
Beeper Control

5.3 Operation

Before attempting to operate refer to Section 4, Pool Water Preparation. Also, do not adjust Chlorine
production above 00% until it is certain that salt has been dissolved in pool. Operating without salt
will damage Electrolytic Cell.
NOTE Chlorine Production can be adjusted in 5% increments at the AquaLink RS.
• Check Chlorine Level on a regular basis and adjust AquaPure accordingly.
NOTE Exception - For Cold Weather Operation: If the AquaPure is set to run 24 hours a day through the winter,
extremely cold water temperatures can effect Cell life. Sometimes it will be necessary to run the AquaPure at
a very low production rate of 10% to 20% or to turn the unit off. See Section 6.6, Winterizing.
Beeper operation and volume control can be adjusted.
To adjust volume control, press and hold the TEMPERATURE button
for 15 seconds. The system will beep once when pressed, once after 10
seconds and once after 15 seconds. Release the key after the third beep.
Press the SALINITY button within 5 seconds to enter the temperature
change screen.
The system will display a '1' followed by 'F' or 'C'. Press the
TEMPERATURE button to move to the second parameter screen. The
screen will display a 0, and the beeper volume will be fully reduced. The
system will occasionally show a '2' to display the screen number.
Press the arrow button B to increase the volume and the arrow button
A to reduce the volume. The volume increments from 0 to 100 in 20
steps. After each press of the arrow buttons, the beeper will activate to
demonstrate the current volume level.
When the beeper volume has been adjusted to the desired setting, press
the SALINITY button to confirm the new beeper volume setting. The
change will be stored in permanent memory.
If you do not wish to keep the change, wait 5 seconds, and the change
screen will 'time out' and return to normal operation without keeping
any changes to the system. Any changes made to the beeper volume will
NOT be saved if this occurs.
The Boost cycle is normally activated after 10 seconds, however, if the
key is held down until after the third beep at 15 seconds, the Boost mode
will not be changed.
CAUTION