Reading The Display - Jandy PureLink Installation And Operation Manual

5.2 Reading the Display

Cell On
Cell Resting
Flow or No Flow Indication
Cell Reversing
Salinity
Add Salt
Service and Service Code
NOTE See Section 7.2, Service Codes. Problems can range from insufficient salinity to the DC cord not
connected.
Audible Alarm
NOTE The audible alarm can be permanently disabled by removing the blue jumper from J10 on the power
center front cover PCB.
The indicator shows that the cell has been turned on by the
CELL ON
AquaPure. Some reasons for the
normal operation, are:
CHLORINE PRODUCTION
set to less than 100% and
PRODUCTION
rest period, condition, two minutes before automatic cleaning
NO FLOW
cycle, Low temperature cut off has been activated, or a service related
problem such as a salinity level below 2.0 gpl or salinity level too high.
During the Normal chlorine production cycle when the unit is set for less
than 100%, the cell will periodically rest; that is, the unit will not make
chlorine. The
CELL RESTING
turned off by the power center.
When the power center determines that water is flowing past the Flow/
Temp/Salinity Sensor, the
detected, the
NO FLOW
The automatic cleaning cycle of the AquaPure is in progress. The
cleaning cycle is factory set and cannot be adjusted. Cell Reversing does
not interrupt the production of Chlorine.
Salinity is displayed along with the
the button is depressed. If a reading of HH appears, the salinity
Salinity
is above 4.5 to 6.5 gpl (depending on pool temperature) and is too high to
measure correctly (at normal temperatures). Maintain Salinity between
3.0 and 3.5 gpl. See Section 4.
The indicator comes on when the Flow/Temp/Salinity Sensor
ADD SALT
determines that the salinity level of the pool water is too low. Maintain
Salinity between 3.0 and 3.5 gpl.
The indicator will turn on whenever the AquaPure detects a
SERVICE
problem that requires attention. The
by a service code displayed on the front panel, displayed as a 3 digit
code. The service code(s) are displayed twice per minute with an audible
alarm.
An audible alarm (beep) sounds once per hour, and only for the first
service code when a
Service
cleared by pressing and holding the
audible alarm can be cleared for 24 hours or until the power to the unit
is turned off and back on whichever comes first. However, the audible
alarm will return if a new problem is detected.
indicator not being on during
CELL ON
Cell Resting
indicator shows that the cell has been
indicator is displayed. When no flow is
FLOW
is displayed and the cell is turned off.
(grams per liter) indicator, when
gpl
indicator is accompanied
SERVICE
condition is detected. The Alarm can be
button
Salinity
Page 27
set to 00%,
CHLORINE
appears during cell
for 5 seconds. The
C