Water purification system power center and cell kit (44 pages)
Summary of Contents for Jandy SFTM PRO Series
Page 1
Installation and Operating Data Sand Filter Installation and Operation Manual WARNING Before installing this product, read and follow all warning notices and instructions that accompany this filter. Failure to follow warning notices and instructions may result in property damage, severe injury, or death. FOR YOUR SAFETY - This product must be installed and serviced by authorized personnel, qualified in pool/spa installation.
Filter Location........4 Troubleshooting........8 Filter Installation........5 SECTION 9 SECTION 4 Exploded View and Parts List Start-up and Operation ™ Jandy SF-T Series......9 New Pool and Seasonal Start-up.... 5 Jandy ™ ST-T Series....... 9 Normal Operation........6 ™ Jandy SF24-S ........
Page 4 SECTION 1. Safety Information 1A. Important Safety Warning WARNING- NEVER OPERATE THIS FILTER SYSTEM AT MORE THAN 50 PSI. THIS FILTER OPERATES UNDER HIGH PRESSURE, WHEN ANY PART OF THE CIRCULATING SYSTEM, i.e., FILTER, PUMP, VALVE(S), CLAMPS, ETC. IS SERVICED, AIR CAN ENTER THE SYSTEM AND BECOME PRESSURIZED WHEN THE SYSTEM IS STARTED.
Provide barrel unions to each item of equipment SECTION 2. for future servicing of equipment. All Teledyne General Information Laars/Jandy Products filters come with these type of fittings. 2A. Introduction The maximum working pressure for SF-T & This manual contains information for the proper...
Page 7 Position the filter to safely direct water drainage. 3B. Filter Location Align the pressure release valve to safely direct Select a well-drained area, one that does not purged air or water. flood when it rains. Damp, non-ventilated areas should be avoided.
Page 8 WARNING If the system is to be installed below water level, valves should be on both the suction and return Water discharged from an improperly positioned filter lines to prevent back flow of pool water during or valve can create an electrical hazard which can any routine servicing that may be required.
Page 9 4B. Normal Operation SECTION 5. With the pump off, set MPV handle to "Filter" Backwashing the Filter position. Caution Fill the hair/lint pot, on the pump, with water. Be sure all provisions for waste water disposal meet applicable local, state or national code. 100 gals. or Open filter pressure release valve, stand clear of more of pool water will be discharged during filter the filter, and turn the pump on.
Keep the pressure gauge in good working order. If you suspect a problem with the gauge, To eliminate stress on the laterals, fill tank Teledyne Laars/Jandy Products recommends you with enough water to cover the laterals. Pour call a qualified service technician to do any sand in slowly.
Page 11 SECTION 8. Troubleshooting 8A. Troubleshooting Teledyne Laars/Jandy Products recommends that you call a qualified service technician to do any work on the filter/pump system. For technical service call 415-382-8220, ext. 260. Troubleshooting Guide Fault Symptom Possible Problems Water is not clear.
Page 16
If the dealer is not available, you can locate a service center in your area by visiting www.jandy.com or by calling our technical support department at (707) 776-8200 extension 260. All returned parts must have a Returned Material Authorization number to be evaluated under the terms of this warranty.