Fan Without Light Kit; Installing The Light Kit - HAMPTON BAY 164-352 Owner's Manual

Installing the
Light Kit
CAUTION
BEFORE STARTING INSTALLATION, DISCON-
NECT THE POWER BY TURNING OFF THE
CIRCUIT BREAKER OR REMOVING THE FUSE AT
FUSE BOX. TURNING POWER OFF USING THE FAN
SWITCH IS NOT SUFFICIENT TO PREVENT
ELECTRIC SHOCK.
While holding the light kit assembly under
1.
your fan, locate two single white and blue
wires in the switch housing labeled "FOR
LIGHT". Make the polarized plug connec-
tions:
- White to white
- Blue to black
2. Carefully push all wires back into the switch
housing, then install the light kit assembly onto
the switch housing with 3 screws provided. Be
sure to tighten all screws. (Fig. 20)
Install 1 x 13 watt compact fluorescent bulb
3.
(included) into the light kit socket. NOTE:
CFL bulbs are NOT dimmable.
Mount the glass shade to the light fixture by
4.
unscrewing partway the thumbscrews on the
glass holder, insert the glass, then gently
tighten the thumbscrews by hand evenly to the
glass. DO NOT OVER TIGHTEN. (Fig. 20)
5. Restore power and your light kit is ready for
operation.
NOTE
LIGHT BULBS HAVE NO WARRANTY; CAN BE
PURCHASED AT ANY HOME DEPOT STORE.
Switch
Housing
Wire Connectors
Light Kit
Assembly
Bulb

Fan without Light Kit

(Optional)
1. Disassemble the switch housing cover from the
light kit, you can keep the light kit for future
use.
Attach the plastic plug to the switch housing.
2.
(Fig. 21)
3. Install the switch housing cover to the switch
housing with screws provided.
Thumb Screws
Switch Housing
Switch Housing
Cover
Glass Shade
Figure 20
Screws
Plastic Plug
Figure 21
11