Fan Without Light Kit - HAMPTON BAY Palisades Owner's Manual

Fan Without Light Kit

1. In order to use the fan without the light kit,
remove the switch cup cover from the top of
the light kit by removing the center hex nut
inside the switch cup cover, and then thread
the switch cup cover off of the threaded
nipple on the top of the light kit.
2. Press the plastic plug (provided) into the
center hole of the switch cup cover.
3. Loosen the three serrated head screws on
the switch cup cover. Align the three screws
on the switch cup cover with the three key
slots in the switch cup. Make sure the notch
in the switch cup cover clears the reversing
switch in the switch cup (refer to figure 15
on page 9).
4. Position the switch cup cover onto the
switch cup and turn it clockwise until it
locks. Tighten the three serrated head screws
that were loosened in step 3.
10.
Key Slots
Plastic Plug
Serrated Head
Screw (3)
YOUR FAN/SWITCH CUP COVER MAY NOT LOOK
EXACTLY LIKE THE ILLUSTRATION, HOWEVER
THE INSTALLATION IS THE SAME.
Reverse
Switch
Figure 17