Fan Without Light Kit - HAMPTON BAY Lynwood Owner's Manual

8.

Fan Without Light Kit

1. In order to use the fan without the light kit,
remove the switch cup cover from the top
of the light kit fitter by removing the center
hex nut inside the switch cup cover, and
then thread the switch cup cover out of the
threaded nipple on the top of the light kit
fitter. Remove three serrated head screws.
2. Press the plastic plug (provided) into the
center hole of the switch cup cover.
3. Align the three screw holes in the switch
cup cover with the three key slots in the
switch cup. Make sure the notch in the
switch cup cover clears the reversing
switch in the switch cup (refer to Figure 12
on page 7).
Figure 13
4. Position the switch cup cover onto the
switch cup and install the three serrated
head screws that were removed in step 1.
Turn the switch cup cover clockwise until
it locks, tighten the three serrated head
screws.
YOUR FAN/SWITCH CUP COVER MAY NO
LOOK EXACTLY LIKE THE ILLUSTRATION.
HOWEVER, THE INSTALLATION IS THE SAME.
Figure 14