Fan Without Light Kit; Installing The Light Kit - HAMPTON BAY Rocio Owner's Manual

Installing the
Light Kit
NOTE
BEFORE STARTING INSTALLATION, DISCON-
NECT THE POWER BY TURNING OFF THE
CIRCUIT BREAKER OR REMOVING THE FUSE
AT FUSE BOX. TURNING POWER OFF USING
THE FAN SWITCH IS NOT SUFFICIENT TO
PREVENT ELECTRIC SHOCK.
1. While holding the light kit assembly under
your fan, snap together the wire connection
plugs.
2. Carefully push all wires back into the switch
housing, then install the light kit assembly onto
the mounting plate with 3 screws provided. Be
sure to tighten all screws. (Fig. 16)
Install 2 x 13 watts compact fluorescent bulbs
3.
(included). NOTE: CFL bulbs are NOT
dimmable.
4. Raise glass shade up against the light kit and
secure it to fan by turning glass counterclock-
wise until snug. DO NOT OVERTIGHTEN.
(Fig. 16)
5.
Pass the two pull chains on the light kit through
the chain holders located on the light fitter,
install the fobs to the pull chains. (Fig. 16)
6.
Restore power and your light kit is ready for
operation.
10
NOTE
LIGHT BULBS HAVE NO WARRANTY; CAN BE
PURCHASED AT ANY HOME DEPOT STORE.
Wire Connection
Plugs
Light kit
Assembly
Bulbs

Fan without Light Kit

(Optional)
1. Disassemble the switch housing cover from the
light kit, you can keep the light kit for future
use.
2. Attach the plastic plug to the switch housing.
(Fig. 17)
3. Holding the switch housing under your fan,
snap together the wire connection plugs.
Install the switch housing cover to the switch
4.
Mounting Plate
housing with screws provided.
Pull Chains
Wire Connection
Plugs
Glass Shade
Extra Plastic Plugs
Figure 16
Screws
Switch Housing
Figure 17