Fan Without Light Kit; Installing The Light Kit - HAMPTON BAY 420-420 User Manual

N O T E : B e f o r e s t a r t i n g i n s t a l l a t i o n ,
disconnect the power by turning off the circuit
breaker or removing the fuse at fuse box.
Turning power off using the fan switch is
not sufficient to prevent electric shock.
1. H olding the light kit assembly under your
fan, snap together the wire connector
plugs .
2. Carefully push all wires back into the
switch housing, then install the light kit
assembly onto the mounting plate with 4
screws provided. Be sure to tighten all
screws. (Fig. 17)
3. Remove the lock ring from the socket by
turning the lock ring counter-clockwise
Until it unlocks. Insert the glass into the
glass holder and turn the lock ring
clockwise to tighten the glass. Repeat
for the remaining glass. (Fig. 17)
4. With the power off, insert the light bulbs
(not included) into the light kit sockets.
Max. 60 watts.
5. Restore power and your light kit is ready
for operation.
9.

Installing the Light Kit

Wire connection
plugs
Glass holder
Glass shade
Lock ring
Bulbs
Figure 17

Fan Without Light Kit

(Optional)
1. Disassemble the wire harness from the
light fixture, you can keep the light fixture
for future use.
2. Install the wire harness into the empty switch
box by placing the pull chain switch and
reversing switch into the holes located in the
empty switch box (see illustration), secure the
Screws
pull chain switch and reversing switch with
original nut and screws.(Fig. 18)
Light kit
3. Tuck the wire harness into the switch box.
assembly
4. Remove the screws from the mounting ring
under the fan motor. Raise the switch box to
the mounting ring until the holes in switch box
and mounting ring line up.
screws to secure in place.
Wiring harness
Reversing switch
Screw
Figure 18
FOR NON-LIGHT USE PURPOSE, THE SWITCH
BOX IS AV AILABLE BY CALLING THE TOLL
FREE NUMBER1- 877-902-5588
Reinsert the
Pull chain
switch
Nut
Empty switch box
NOTE