Installing The Light Kit; Fan Without Light Kit - HAMPTON BAY Rapallo 110-083 Owner's Manual

Installing the
Light Kit
CAUTION
BEFORE STARTING INSTALLATION, DISCONNECT
THE POWER BY TURNING OFF THE CIRCUIT
BREAKER OR REMOVING THE FUSE AT FUSE
BOX. TURNING POWER OFF USING THE FAN
SWITCH IS NOT SUFFICIENT TO PREVENT
ELECTRIC SHOCK.
1. While holding the light kit assembly under
your fan, snap the wire connection plugs
together (Fig. 13).
Carefully push all wires back into the switch
2.
housing, then install the light kit assembly onto
the mounting plate with 3 screws provided. Be
sure to tighten all screws. (Fig. 13)
Install 2 x 13 watts compact fluorescent bulbs
3.
(included) into the light kit sockets. NOTE:
CFL bulbs are NOT dimmable.
4. Remove the metal nut, glass cap and decorative
nut from the light kit. Place glass shade over
the light kit stem, secure with the metal nut
(rubber side on the top), glass cap and decora-
tive nut. Do not overtighten (Fig. 13).
5. Insert the 2 pull chain through the eyelet in the
shade and cap. Secure the glass cap and
decorative nut provided (Fig. 13).
Restore power and your light kit is ready for
6.
operation.
8
NOTE
MAKE SURE TO LEAVE ENOUGH SPACE
BETWEEN THE FAN PULL CHAIN AND THE
BULBS SO THE CHAIN DOESN'T RUB AGAINST
ANY OF THE BULBS.
Wire Connection
Plugs
Light Kit
Assembly
Bulbs
Metal Nut
Glass Cap
Decorative Nut
NOTE
LIGHT BULBS HAVE NO WARRANTY; CAN BE
PURCHASED AT ANY HOME DEPOT STORE.

Fan without Light Kit

(Optional)
Disassemble the switch housing from the light
1.
kit, you can keep the light kit for future use.
2. Attach the plastic plug to the switch housing.
(Fig. 14)
Holding the switch housing under your fan,
3.
snap the wire connection plugs together .
Mounting Plate
4. Install the switch housing to the mounting
plate with screws provided. (Fig. 14)
Screws
Pull Chain
Wire Connection
Plugs
Glass
Shade Switch
Housing
Plastic Plug
Figure 13
Mounting Plate
Screws
Figure 14