Installing A Board - Fujitsu Siemens Computers SCENIC T Operating Manual

System expansions

Installing a board

Ê
Open the casing (see "Opening the casing").
1
Ê
Remove the screw (1).
Ê
Remove the rear slot cover plate from the slot (2).
Do not dispose of the cover plate. For cooling, protection against fire and in order to
i
comply with EMC regulations, you must refit the cover plate if you remove the board.
Ê
Take the new board out of its packaging.
Ê
Make the required settings for the board.
Ê
Push the board up to its slot (3).
Ensure that the end of a long board without angle bracket fits into the corresponding guide of
the casing.
Ê
Press the board into the slot so that it engages.
Ê
Fix the board with the screw (4).
Ê
If necessary, connect the cables.
Ê
Close the casing (see "Closing the casing").
If you have installed or removed a PCI board, please check the relevant PCI slot settings
i
in the BIOS Setup. If necessary, change the settings. Further information is provided in the
PCI board documentation.
36
2
Installing and removing a board
4
3
A26361-K657-Z101-4-7619