Working With Floppy Disks; Settings In Bios Setup - Fujitsu Siemens Computers SCENIC T Operating Manual

Working with floppy disks

Working with floppy disks
Follow the instructions supplied by the vendor of the floppy disks.
i
Never clean the floppy disk drives with cleaning disks. Any attempt would destroy the
read/write head in the disk drive within 20 seconds.
1
1 = Insertion direction
2 = Label area
3 = Write protection switch for a 720 KB or a 1.44 MB floppy disk
4 = Identification of a 1.44 MB floppy disk or write protect switch on a 120 MB floppy disk
5 = Eject button for inserted floppy disks
6 = Disk is write-protected
7 = Disk is not write-protected
To insert a diskette:
Ê
Push the floppy disk into the drive in the insertion direction (1) until it engages. The label
should be facing upward.
To remove a diskette:
Ê
Push the eject button (5).
Protect the floppy disk against being overwritten or erased
Ê
Slide the write-protect slider into position (6). The hole is now visible.
Deactivate write protection
Ê
Slide the write-protect slider into position (7). The hole is now covered.

Settings in BIOS Setup

The BIOS Setup menu allows you to set your hardware configuration and system functions. When the
PC is delivered, the default entries are valid (see Technical Manual for the system board or the
manual "BIOS Setup"). You may customise these settings to your requirements in the BIOS Setup.
The Technical Manual for the system board shows you how to call and operate BIOS Setup. The
menus and setting options provided by the BIOS Setup are also described in detail.
A26361-K657-Z101-4-7619
5
2
3
6
4
Operation
7
23