Installing A Board - Fujitsu Siemens Computers SCENIC eT Operating Manual

System expansions

Installing a board

Ê
Open the system unit (see
1
Ê
Remove the screw (1).
Ê
Remove the rear slot cover plate from the slot (2).
Do not dispose of the rear slot cover plate. For cooling, protection against fire and in order
i
to comply with EMC regulations, you must refit the rear slot cover plate if you remove the
board.
Ê
Take the new board out of its packaging.
Ê
Make the required settings for the board.
Ê
Push the board up to its slot (3).
Ensure that the end of a long board without angle bracket fits into the corresponding guide of
the system unit.
Ê
Press the board into the slot so that it engages.
Ê
Fix the board with the screw (4).
Ê
If necessary, plug the lines on the board.
Ê
Close the system unit (see
If you have installed or removed a PCI board, check in the BIOS Setup the settings for the
i
relevant PCI slot. If necessary, change the settings. Further information is provided in the
documentation for the PCI board.
28
"Opening the system
2
"Assembling the system
Installing and removing a board
unit").
4
3
unit").
A26361-K554-Z100-2-7619