Removing A Board - Fujitsu Siemens Computers SCENIC T Operating Manual

Installing and removing a board

Removing a board

Ê
Open the casing (see "Opening the casing").
Ê
Disconnect the cables connected to the board.
1
2
Ê
Remove the screw (1).
Ê
Pull the board out of the casing (2).
Ê
Place the board into appropriate packaging.
To ensure proper cooling, fire protection and observation of the relevant EMC
!
(electromagnetic compatibility) regulations, you must mount a rear slot cover plate.
Ê
Push the rear slot cover plate into the slot (3).
Ê
Fasten the rear slot cover plate with the screw (4).
Ê
Close the casing (see "Closing the casing").
If you have installed or removed a PCI board, please check the relevant PCI slot settings
i
in the BIOS Setup. If necessary, change the settings. Further information is provided in the
PCI board documentation.
A26361-K657-Z101-4-7619
3
4
System expansions
37