Preparing For Use; Unpacking And Checking The Delivery; Steps For Initial Setup - Fujitsu Siemens Computers SCENIC T Operating Manual

Preparing for use

!
Please take note of the safety information in the "Important notes" chapter.

Unpacking and checking the delivery

It is recommended not to throw away the original packaging material! It may be required for
reshipment at some later date.
Ê
Unpack all the individual parts.
Ê
Check the delivery for damage incurred during transportation.
Ê
Check whether the delivery agrees with the details in the delivery note.
Should you discover that the delivery does not correspond to the delivery note, notify your local
sales outlet immediately.

Steps for initial setup

First-time setup includes the connection of the monitor, mouse, and keyboard to the PC and the
setup of the supplied software.
External devices
i
If you have received other devices in addition to your PC (e.g. a printer or a modem), do
not connect these until after the initial installation. The following sections contain a
description of how to connect these external devices: "Connecting external devices to the
serial port" and "Connecting external devices to the parallel port".
Drives and boards
If you have received drives or boards with your PC, please do not install them until after
first-time setup. How to install drives and boards is described in the "System expansions"
chapter.
Perform the following steps in the prescribed order:
1. Decide where you are going to use the PC, and then set it up.
2. Connect the monitor, mouse and keyboard to the PC.
3. Check the rated voltage of the PC and connect it to the mains voltage.
4. Switch the PC on and follow the instructions on the screen.
A26361-K657-Z101-4-7619
7