Table of Contents
Advertisement
SCSI Device Configuration
This option allows you to configure certain parameters of each SCSI device on the
SCSI bus. A screen similar to the figure below appears. The screen shows a
column of information for each SCSI ID, even if some SCSI IDs are not assigned to
a device. To configure a specific SCSI device, you need to know which SCSI ID it
uses. See SCSI Disk Utilities later in this section to learn how to determine which
SCSI ID is used by which device.
Adaptec AIC-7896
Configuration
SCSI Device ID
SCSI Bus Interface Definitions
Sync Transfer Rate (MB/Sec) .....80.0
Initiate Wide Negotiation ............. Yes
Enable Disconnection ................. Yes
Send Start Unit Command .......... Yes
Additional Options
Enable Write-back cache ............ N/C
--------------------Options Listed Below Have NO EFFECT if the BIOS is Disabled -----------------
BIOS Multiple LUN Support .........No
Include in BIOS Scan.................. Yes
SCSI Device ID
Sync Transfer Rate (MB/Sec) .....80.0
Initiate Wide Negotiation ............. Yes
Enable Disconnection ................. Yes
Send Start Unit Command .......... Yes
Enable Write Back Cache ........... N/C
--------------------Options Listed Below Have NO EFFECT if the BIOS is Disabled -----------------
BIOS Multiple LUN Support .........No
Include in BIOS Scan
Figure 5-8 SCSI Device Configuration Screen for AIC-7896
Use the cursor keys (↑ ↓) to move between options. Press Enter to display a pop-
up menu with a selection of values. Use the cursor keys (↑ ↓) to select a value,
and press Enter to make your selection.
Altos 12000 Series User's Guide
AIC-7896 at Bus:Device 01:06h
SCSI Device Configuration
SCSI Device Configuration
#0
Host Adapter SCSI ID................................ 7
SCSI Parity Checking ................................ Enabled
Host Adapter SCSI Termination................. Low ON/High ON
Boot Device Options .................................. Press <Enter>
SCSI Device Configuration ........................ Press <Enter>
Advanced Configuration Options ............... Press <Enter>
<F6> - Reset to Host Adapter Defaults
#8
Yes
Some older SCSI-1 devices do not support
synchronous negotiation, so your computer
might operate erratically if Initiate Sync
Negotiation is enabled.
Negotiation to No for these devices.
SCSISelect (TM)
#1
#2
#3
80.0
80.0
80.0
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
N/C
N/C
N/C
No
No
No
Yes
Yes
Yes
#9
#10
#11
80.0
80.0
80.0
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
N/C
N/C
N/C
No
No
No
Yes
Yes
Yes
Set Initiate Sync
Utility
#4
#5
#6
80.0
80.0
80.0
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
N/C
N/C
N/C
No
No
No
Yes
Yes
Yes
#12
#13
#14
80.0
80.0
80.0
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
N/C
N/C
N/C
No
No
No
Yes
Yes
Yes
#7
80.0
Yes
Yes
Yes
N/C
No
Yes
#15
80.0
Yes
Yes
Yes
N/C
No
Yes
Advertisement
Table of Contents
