Boot Device Option Screen - Acer Altos 12000 Series User Manual

Boot Device Options
This option shows the target ID of the device you are booting from. The default
setting is 0 (zero). We recommend that you not change this setting. Some
operating systems will not run unless the boot device is set at zero.
The figure below shows the Boot Device Options screen.
Configuration
SCSI Bus Interface Definitions
Additional Options
Select SCSI peripheral from which to boot
To view peripheral by ID# select "SCSI Disk Utilities" from previous menu
Boot Channel ....................................................................................
Boot SCSI ID........................................................................0
-----------Options Listed Below Have NO EFFECT if Multiple Lun Support is Disabled-------------
Boot Lun Number.............................................................................. 0
Arrow keys to move cursor, <Enter> to select option, <Esc> to exit (
Figure 5-7 Boot Device Options Screen
Boot Channel
MultiChannel devices allow you to boot from either channel. Use this option to
identify the channel which should be scanned first during bootup. The default is
A First.
Altos 12000 Series User's Guide
Adaptec AIC-7896
AIC-7896 at Bus:Device 00:00h
Host Adapter SCSI ID ................................... 7
SCSI Parity Checking.................................... Enabled
Host Adapter SCSI Termination.................... Disabled
Boot Device Configuration
Boot Device Options...................................... Press <Enter>
SCSI Device Configuration............................ Press <Enter>
Advanced Configuration Options................... Press <Enter>
<F6> - Reset to Host Adapter Defaults
SCSISelect (TM) Utility
A First
* =default)