User Mode - Brother HL-5340D Service Manual

1.2

User Mode

Basically, user mode should be accessed by service personnel only. Assist as needed, when
the telephone support, end users can operate under service personnel order.
<Procedure>
<LED model>
(1) Check that the front cover is closed.
(2) Turn ON the power switch while holding down the [Go] button.
(3) After all LEDs on the panel are lit, only the Status LED goes out.
(4) Release the [Go] button and check that all LEDs are off.
(5) Press the [Go] button depending on the necessary number of times.
(If the [Go] button is pressed, the Status LED is lighted. If the [Go] button is released,
the LED is out.)
<LCD model>
(1) Check that the front cover is closed.
(2) Turn ON the power switch while holding down the [Go] button.
(3) The message "USERS MODE" is shown on the LCD panel with the orange backlight.
(4) Release the [Go] button and check that the Data LED is off.
(5) Press the [Go] button depending on the necessary number of times.
(If the [Go] button is pressed, the Data LED is lighted. If the [Go] button is released, the
LED is out.)
Press the [Go] button
Once
Twice
Three times
Four times
Five times
Six times
Seven times
Eight times
Nine times
Ten times
11 times
12 times
More than 13 times
CAUTION;
• Each mode starts 2 seconds after pressing the [Go] button.
• If the [Go] button is pressed, the Status LED is lighted. If the [Go] button is
released, the LED is out.
1) Test Sample Page
2) Print Fonts
3) 1push Printing Recovery Mode
4) Hex Dump Mode
1) Test Sample Page
5) Network Reset (APIPA: ON)
1) Test Sample Page
6) Factory Reset
1) Test Sample Page
7) Settings Reset
1) Test Sample Page
8) PCB ONLY Mode
1) Test Sample Page
7-3
Mode
Confidential