Brother HL-5340D Service Manual page 123

< Installing Procedure >
(1) Secure the Laser unit with the six cup S M3x6 Taptite screws.
(2) Put the Flat cable (LD harness connector) through the Core.
(3) Put the Flat cable (Polygon motor connector) through the Core and Protective film.
(Refer to "6. HARNESS ROUTING" in Chapter
(4) Connect the two Flat cables to the Main PCB.
Note :
• When connecting flat cable(s), do not insert them at an angle. After insertion, check
that the cables are not at an angle.
Taptite, cup S M3x6
LD harness connector
(Flat cable)
Wireless PCB harness
Main PCB
Polygon motor connecter
(Flat cable)
Laser unit
Core
Laser unit
Protective film
Fig. 4-18
4-13
5.)
LD harness connector
(Flat cable)
Taptite, cup S M3x6
Wireless PCB harness
core
Protective film
Polygon motor connector
(Flat cable)
<Main PCB>
Confidential