Method Of Entering End-User Accessible Maintenance Mode - Brother HL-3160CDW Service Manual

1.1.2

Method of entering end-user accessible maintenance mode

The maintenance mode functions should only be accessed by service personnel. However,
end users are allowed to use some of these functions under the guidance of service personnel
over the phone. End users can only use the functions shaded in the table
Maintenance Mode Functions"
80, 82, 91).
< Operating Procedure >
For models with touch panel
(1) Press and hold the
seconds while the machine is in the ready state.
The display shown on the right appears on the
LCD.
(2) Press the blank field at the bottom on the LCD.
The display shown on the right appears on the
LCD.
(3) Press the [*], [0], and [#] on the LCD in this order.
The machine enters into ready state to accept
function code entry, so press the function code
you want to execute.
(4) Each time the selected maintenance mode
function is completed, the machine returns to the
ready state automatically.
For models without touch panel
(1) Press the [OK], [Go], and [OK] in this order while the machine is in the ready state. "0" is
displayed on the LCD.
(2) Press the [▲] or [▼] to display the function code you want to execute on the LCD and
press the [OK].
(3) Each time the selected maintenance mode function is completed, the machine returns to
the ready state automatically. However, for function codes 12, 25, 45, 80, and 82,
pressing the [Stop/Exit] returns the machine to the ready state.
(Function code 09, 10, 11, 12, 25, 45, 61, 66, 68, 71, 72, 77,
for approximately five
5-2
"1.2 List of
Confidential