Brother HL-5340D Service Manual page 283

Press the [Go] button twice.
Press the [Go] button again depending on the necessary number of times after check
that Toner/Drum/Paper LEDs are lighted.
Press the [Go] button
Once
Twice
Three times
Four times
Five times
Six times
Seven times
Eight times
Nine times
Ten times
More than 11 times
Press the [Go] button three times.
Press the [Go] button again depending on the necessary number of times after check
that Toner/Drum/Paper LEDs are lighted.
Press the [Go] button
One to eight times,
ten to 12 times
Nine times
Press the [Go] button more than 2 seconds (long push).
Check that Paper LED is lighted.
PIT3 Inspection Mode
CAUTION;
• Each mode starts 2 seconds after pressing the [Go] button.
• If the [Go] button is pressed, the Status LED is lighted. If the [Go] button is
released, the LED is out.
17) Printing for Maintenance
* Start printing when close the front cover.
18) Maintenance + Test pattern with margin frame
(DX/LongBind)
(HL-5340 is the print test)
* Start printing when close the front cover.
19) Network Config Printing
(HL-5380DN is the print test)
* Start printing when close the front cover.
20) Sleep Mode Setting (ON/OFF)
* Check that all LEDs are lighted for one second.
Ineffective
21) Developer Roller Counter Reset 2
(For the standard toner cartridge)
* Check that all LEDs are lighted for one second.
21) Developer Roller Counter Reset 3
(For the high-capacity toner cartridge)
* Check that all LEDs are lighted for one second.
22)Fixed USB Speed Mode
23) USB Speed Indication (ON/OFF)
24) Sleep Mode Indication (OFF/Dimmed)
Go back to Normal State
Factory use
25) Inspection Mode Clearance + Inspection Mode
Mask
* Factory use.
7-6
Mode
Mode
Confidential