Local Network - FLIR DNE14TL2 Instruction Manual

6.7.1 Local Network

The Local Network page shows the camera's current IP address and
network parameters if DHCP is enabled. It also allows you to set a static IP
address for the camera (see below), set the networking parameters, and to
select IPv4 or IPv6.
NOTE: DHCP is enabled by default. When DHCP is enabled, the IP address
is shown under DHCP IP. Once you have completed the basic setup of the
camera, it is recommended to configure a static IP address. This will
prevent the camera IP address changing in the event of a power failure.
To configure the camera's networking parameters:
1. Click Device Configuration>Local Network.
2. Under IP Protocol, select IPv4 or IPv6. If you would like to use IPv6, make
sure it is supported on your network. You may need to contact your
network administrator or ISP for details.
3. Select Device obtain an IP address automatically to use DHCP or Device
use the following IP address to set a static IP address for the camera. If
you are using a static IP address, configure the following:
• IP Address: Enter the IP address you would like to assign to the camera.
Make sure the IP address is available on your network.
• Subnet Mask: Enter the subnet mask.
• Preferred DNS Server/Alternate DNS Server: Enter desired DNS
servers.
Web Configuration
27